Welcome to our forum.
Does any water flow through anything at all?
Are you sure that you just don't have an air lock? Have you tried to bleed the pumps?
I bled the circ pump and water is flows to the pump - but the line going from the circ pump is stopped up. I figured the circ pump was the right one to work on since it has the heater in-line ?I was going to work on the main pumps - but ran out of light and warmth.......
I would bleed the main pumps and get them working then they will heat everything else. It's not uncommon to have an air lock in the circ system past the pump while still getting water to the pump itself. HS used to have an air bleed system that connected all the pumps together so I would work on those jet pumps ASAP! It kinda sounds like an airlock....
Well - holy icicles - I flipped the breakers again - and nothing.....but couldnt see the panel as the cover was covering it...and I hit jet pump 1 by mistake and - it worked !!!! So I let it run for about a minute...then shut it off....the circ pump still wasnt circulating.......then i saw slushy water came thru and started to flow !! - So I hit jet pump 2 - and nothing......So now I have the circ pump working and the tub already went up 2 degrees in 15 mins....and Jet pump one works.....it did sound like there was some air in it.I am going to let the circ pump run for an hour or so...then I will go back out to see if 2 will work - if not...then I will bleed it tomorrow after work. So - I am half way to spatopia.......I just wish it wasnt this hard.... :-/