Original > Hot Tub Forum

Dim Hot Springs Exterior Logo Light?

(1/4) > >>

JB0113:
I just recently got a new Hot Springs Flair that I am thoroughly enjoying. The logo light on the exterior of the tub, however, is extremely bright. Like bright enough to light up some of the patio in front of the tub, fence, and even a bit of my neighbors screened in porch when it's extremely dark outside. It's not a huge deal by any means but I was thinking about purchasing some kind of tint film on Amazon to put it over the exterior light. Curious if anyone else has done something similar and how it held up in the elements.

Thanks!

d00nut:
I believe you can dim it via software.  You have to go into the service menu... which I absolutely hate telling customers to do it... because they could really screw up the hot tub software.

A lot of times if a customer is making comments about the brightness, next time we are in the area, we will go out and dim it via the software as a courtesy.

I believe there are 3 levels of dimness.

Worst case, the easiest thing for you to do is to just unplug it.  If you place something on it (I had a customer use duct tape....) it could ruin it long term.  No one has tried the tint film to my knowledge yet.

WarmWaterOasis:
Well, that would make sense! Do you care to share the details on how to do that for me here or via private message/email?  It would be greatly appreciated!  I consider myself pretty confident when it comes to this kind of thing so I wouldn’t necessarily be opposed to doing it myself.  Let me know when you can!  Thanks for the reply!

d00nut:
It's no secret ;)

You have to open your black IQ box.  With the power on, there is a small, around half the size of a pencil eraser, white button on the top right side of the IQ Board.

With the power on, press and hold it while looking at your controls.

This is where we tell the spa, how many pumps does it have, if we run the heater concurrent, what lighting zones... all that crap, so you can see it's easy to screw up and confuse the crap out of your hot tub.

You basically will keep hitting next until you get to logo light.  There you will see that you can dim it.

If you start this process and think... I really don't want to mess this up.  Message me later.  I'm not at the store now, but I can make a little video on how to do it if need be later this week

JB0113:
I appreciate it!  If you could make a video for me on exactly how to do it, that would be fantastic!  Thanks!

Navigation

[0] Message Index

[#] Next page