Brand Specific Forums > Marquis Hot Tubs

Marquis Reward not working anymore...

<< < (2/4) > >>

mike159sw:
@hottubguy, nothing is working at all. When I connect the power direct to one of the pomps, it started to work....

@ Jaczzi Jim, sorry man...I've checked the fuses with a multimeter. I took the fuses out of the mainboard. You lose your 10 bucks :P

Jacuzzi Jim:
 No I lose a dime.  ;D    I am still going with the fuse, if not possibly a bad top side.   Leave one end of the fuse still in the board and check the other end.   Should read 0 if I remember right, been awhile.

MarKee:
Could possibly be the heater. Try unhooking the heater and see if it turns on. Very important to use 2 wrenches when unhooking the copper bands or wires that connect the heater to the PC board. Use 1 wrench to hold the metal studs that go in to the heater, and the other wrench to loosen the nuts.  If it works with the heater being unhooked, that tells you that you need a new heater.

mike159sw:
@ Markee, I've disconnected the heater, but no result. I did some checks at the mainboard but after one fuse there is no power anymore. Even the light, which should have 12V, is powerless.

@ Jacuzzi Jim, You own me 10 bucks ;) I rechecked the fuses again...the're still ok.

MarKee:
Have you checked to see that there is 200+ volts at the terminal block where the 4 wires connect?

Is it tripping the breaker?

Navigation

[0] Message Index

[#] Next page

[*] Previous page