Hot Tub Forum

General => Hot Tub Forum => Topic started by: huongtranbong on January 09, 2019, 08:25:00 pm

Title: Caldera Error Code
Post by: huongtranbong on January 09, 2019, 08:25:00 pm
2016 caldera vanto

So yesterday, as I am still trying to troubleshoot my GFCI tripping problem, I pulled the board out to inspect it.  Board looked fine so I put it back in, attached all wires, and ensured the setup was correct (software jumpers).  Fired it it, and all worked.

Today I went out to check on it.  Pump 1 low speed works, but when i push pump 1 high speed I get a ===== code with READY and JETS flashing and the pump cuts off.  When i push Jets again, pump 2 comes on just as it should.  Therefore, pump 1 high speed is the only thing not working (not even a year since this).  This happened previously and the pump was replaced under warranty.  The manual says the code means the pressure switch is open.  Why would this happen all of a sudden?  Or is there another meaning to the code

Hot tub is at the correct temperature..


Also - does ANYONE have any service manual information on these tubs.  There is literally nothing on the internet. I cant stand not being able to troubleshoot or know what the jumpers mean, etc.
Title: Re: Caldera Error Code
Post by: wmccall on January 10, 2019, 09:32:54 am
Welcome to the forum!  I just wanted to say that till one our Caldera experts come along.
Title: Re: Caldera Error Code
Post by: Hottubguy on January 10, 2019, 02:02:58 pm
When the second pump comes on is the first pump coming on too or staying off?
Title: Re: Caldera Error Code
Post by: castletonia on January 10, 2019, 03:05:47 pm
Is the water level high enough and is the filter clean? 
Title: Re: Caldera Error Code
Post by: gmdodt on January 13, 2019, 11:38:00 am
This is word for word  my post from a while ago. This may be a fake/spam account..