Hot Tub Forum
Original => Hot Tub Forum => Topic started by: anne on March 13, 2006, 10:18:19 pm
-
I realize this will vary with types of heaters, water volume, etc, but about how long will it take a tub to heat up again after a drain and refill? Any general degrees per hour per volume guidelines out there? I will have an Arctic Summit, water volume of 390 gal. Obviously I dont have it yet, or I guess I could answer my own question. :)
-
110 volt = around 3 degrees per hour.
220 volt = around 10 derees per hour.
Generally, a 110 tub will heat from tap water in about 14 -18 hours, a 220 in 4-6 hours.
Longer if you're in a hurry, of course.
-
My tub is 220V and heats 4 degrees per hour, not 10. Others with similar tubs have indicated this is their heat rate also. Tub size is likely to affect rate also...IMO
Steve
-
Hi Anne
Just refilled my Arctic Summit this week. Lets see - I worked it out to about 7-8 degrees/hour.
Up north here the water out of the tap was 46 degrees so to get up to 103 - about 71/2 hrs for us.
Starting temp is key but I would think that the rate of 7/hr should give you a ball-park.
Enjoy the tub!
Jc
-
anne, I have the tundra which has a little more water than the sumit. I filled today, and the tap water was 42 degrees. Two hours later it was 65 degrees. So I would say that Chas is bang on for my tub. 10 degrees an hour.
I also find that if I run the pumps and close the lid, it heats up quicker.
I am about to go in it right now and it is sitting at 104. so nice fresh new water is great.
-
10 degrees per hour, eh? That's impressive! :)
-
Thanks, everyone. I'm already anticipating the "down time" before I get my first hot water, and the delay after my inevitable first monthly refill! And I dont even have the tub yet!!!!! ::) Sore from shoveling gravel, though :-/
-
10 degrees per hour, eh? That's impressive! :)
You've got a heck of a lot more water to heat. Thats why you only get four degrees per hour.