Hot Tub Forum
Original => Hot Tub Forum => Topic started by: bradleyabell on September 24, 2017, 09:18:20 pm
-
I just bought a bullfrog X Series Spa started it up and pump one works perfectly pump to you did not work at all and by that I mean the pump sounds like it’s running but there was no water flow at all in the Jets. I let water drip all of the valve and then I was able to get the Jets to run but it seems like it takes 5 to 10 seconds for certain jets on pump two to start and then once they stop there is a lot of bubbling coming out of those jets any advice or expertise that could fix my issue?
-
Most likely air in the lines, should bleed out pretty quick.
-
sounds like pump 2 has an air lock, you can remove the door panel, locate pump 2 then remove the bleed line to remove the air.
-
sounds like pump 2 has an air lock, you can remove the door panel, locate pump 2 then remove the bleed line to remove the air.
But be careful, it could get messy. I recommend running the pump for an hour. See if that clears it up.
BSFM is it a bleeder line or bleeder plug?
-
sounds like pump 2 has an air lock, you can remove the door panel, locate pump 2 then remove the bleed line to remove the air.
But be careful, it could get messy. I recommend running the pump for an hour. See if that clears it up.
BSFM is it a bleeder line or bleeder plug?
They actually have both, standard "thumb screw" at the bottom of the wet end on the pump and then a bleeder hose attached via clamp at the top of the pump