Hot Tub Forum
Brand Specific Forums => Jacuzzi Hot Tubs => Topic started by: Lawotte on January 01, 2015, 02:26:31 pm
-
I obtained an older Jacuzzi hot tub. The problem is that I set the temperature to 104 but it goes to 111. It shows actual temperture, but doesn't seem to stop at the set temperature. What is the problem?
-
Could be a stuck heater relay or tub may be set to run continuously which in some circumstances the motor heat alone can bring water temp way high. It is a circuit board I take it?
-
How old of a Jacuzzi is it? Most likely a bad temp sensor, is the water actually hot or cold? High limit should trip at 112 or so unless it's really old, some would trip at 120 if I remember right.