Hot Tub Forum

Original => Hot Tub Forum => Topic started by: pologuymanager on April 10, 2014, 12:56:25 pm

Title: J-375 2005 only flo indicator on but circulation and heat work no pumps will go
Post by: pologuymanager on April 10, 2014, 12:56:25 pm

need help with my J-375 2005
flo stays on but no other buttons will turn on.
Circulation pump and heater on but no pumps will turn on?

Title: Re: J-375 2005 only flo indicator on but circulation and heat work no pumps will go
Post by: Jacuzzi Jim on April 10, 2014, 02:44:25 pm

 Possible bad flo switch is likely..

Title: Re: J-375 2005 only flo indicator on but circulation and heat work no pumps will go
Post by: pologuymanager on April 10, 2014, 04:02:17 pm

Thank you Jim
I replaced it last year with the circulation pump.
strangely enough if i turn the unit off for awhile it goes back to normal until it runs awhile?

Title: Re: J-375 2005 only flo indicator on but circulation and heat work no pumps will go
Post by: Jacuzzi Jim on April 10, 2014, 04:47:46 pm

 Take your circ pump filter out for a while see if that makes a difference.

Title: Re: J-375 2005 only flo indicator on but circulation and heat work no pumps will go
Post by: pologuymanager on April 13, 2014, 12:56:14 pm

no difference:(
i ordered a new flo switch
when i turn it off for a few hours its ok for a while but then flo comes back on again!