Hot Tub Forum

Original => Hot Tub Forum => Topic started by: Coolwaves on November 05, 2011, 10:39:06 pm

Title: Proper hot tub lifting
Post by: Coolwaves on November 05, 2011, 10:39:06 pm

Hello,

I have a Master Spa Legacy 5 person hot tub where I need to raise the tub about an inch on each side in order to slide support braces for my Rock it cover lifter. The water has been drained leaving the dry weight of my tub at 650 lbs. I would like to know what is the best way to raise my tub. I do not want the risk of fracturing the shell or any parts of the tub by raising it like in a incorrect spot. Are there any certain lift points for lifting around the base of the tub, or does it matter?  Do I have to go directly under the tub to lift or can I lift from the bottom lip which is just below the side panels ? As for tools is there any special leverage tools or can I simply use a hydrolic car jack ?

Thanks, 
Coolwaves :-\

Title: Re: Proper hot tub lifting
Post by: Tman122 on November 06, 2011, 07:24:49 am

Quote from: Coolwaves on November 05, 2011, 10:39:06 pm

Hello,

I have a Master Spa Legacy 5 person hot tub where I need to raise the tub about an inch on each side in order to slide support braces for my Rock it cover lifter. The water has been drained leaving the dry weight of my tub at 650 lbs. I would like to know what is the best way to raise my tub. I do not want the risk of fracturing the shell or any parts of the tub by raising it like in a incorrect spot. Are there any certain lift points for lifting around the base of the tub, or does it matter?  Do I have to go directly under the tub to lift or can I lift from the bottom lip which is just below the side panels ? As for tools is there any special leverage tools or can I simply use a hydrolic car jack ?

Thanks, 
Coolwaves :-\

I have a couple lever dollies like these. Maybe your rental store will have them.

http://www.gilmorekramer.com/more_info/oak_hardwood_lever_dollies/oak_hardwood_lever_dollies.shtml

Title: Re: Proper hot tub lifting
Post by: Dr. Spa™ Ret. on November 06, 2011, 10:10:21 am

You only need to lift about 1/4", and not the entire spa.  A flat pry bar on the corner should do the trick.

Title: Re: Proper hot tub lifting
Post by: Coolwaves on November 07, 2011, 12:48:09 am

Thanks for all comments. What I ended up doing was that I used my hydrolic car jack with about 8-10 (2 by 4's) about 2 feet in length stacked in order to reach and evenly disperse the weight up under the lip of the shell. Then raised the tub enough on one side where I could easily slide in both support plates to go under the tub.  Worked great.  :)

Title: Re: Proper hot tub lifting
Post by: Grandpaclark59 on November 07, 2011, 04:18:05 am

Looks like you were extra careful to not hurt anything.  Good work!  Things can definitely get tricky when you are moving hot tubs kansas city (http://www.familyleisure.com/Kansas-City/Spas-Hot-Tubs).  :)  Hydrolic jacks make everything a little easier! :)