Hot Tub Forum

Original => Hot Tub Forum => Topic started by: bearpeidog on October 25, 2009, 03:41:54 pm

Title: Removing wires from terminal block
Post by: bearpeidog on October 25, 2009, 03:41:54 pm

Hell- on a host spring terminal block, how do you remove the wires?  It looks like the are pressure clamped through the terminal holes, but can't seem to figure out how to release them.  Thanks!

Title: Re: Removing wires from terminal block
Post by: bearpeidog on October 25, 2009, 03:54:45 pm

Found the answer - posting here in case someone else is looking for it...
You take a small screw driver and pry up in the small square hole located above the wire.  Wire will pop right out.

To insert wire, do the same thing.  Pry up and insert wire.