Hot Tub Forum
Original => Hot Tub Forum => Topic started by: Hotubob2019 on November 26, 2019, 09:07:33 pm
-
When the hotub is turned on, via a breaker, it enters the filter phase but then after about 30 seconds it enters phase 2 with weak jets. The jets have been getting weaker. I have a new filter put in and the water is balanced. Also the control panel shows a 0 (zero) on the display and doesn't respond. The control panel did not work prior to the weak jet issue. I don't know where to start.
-
Check for proper voltage