Hot Tub Forum
Brand Specific Forums => Jacuzzi Hot Tubs => Topic started by: Calisoldier83 on January 19, 2017, 06:50:21 pm
-
Hi,
I just had the ClearRay replaced due to a leak. When I ran the jets the three nights ago, the open flow switch error would flash every 30 seconds. I had to take a video and snip it out to even see it.
The next night it didn't seem to show up while running the jets.
Any ideas on what may be wrong? Jacuzzi is only 2 months old and feel like it's a lemon.
Here is the link to the snap shot:
http://imgur.com/a/Xb8m2 (http://imgur.com/a/Xb8m2)
-
Bad flow switch most likely, call your dealer and tell them to fix it. Lemon, doubtful at this point!