Hot Tub Forum

Brand Specific Forums => Bullfrog Spas => Topic started by: Brookenstein on May 22, 2019, 08:48:10 pm

Title: Question on Bullfrog R7
Post by: Brookenstein on May 22, 2019, 08:48:10 pm

I just had my new tub delivered a few days ago.  I have it set up on the standard water care mode.  I notice that Jet 1 turns on randomly throughout the day.  Is that normal?  It even did it while we were in the tub, after turning all the jets off (after about 45 minutes) maybe 10 minutes later.  The dealer and delivery guys never mentioned that.  I thought maybe it is when the heater is kicking on, but when I check the display it is always at temp.

Any feedback appreciated.

Title: Re: Question on Bullfrog R7
Post by: Sam on May 23, 2019, 12:23:38 pm

Jets 1 will kick on and off throughout the day during the 2 preprogrammed filtration cycles as well as when it calls for heat.  By the way, I think the default filter cycles are a little short and should be increased a bit.  Maybe 4 hours twice per day, but I don't know your bather load. 

In the end, your spa is functioning as intended.