Hi,
Finally took delivery of a Marquis Summit w/ Microsilk. It was installed by our dealer and has been up and running for 24 hours.
Due to no stock anywhere, we weren't able to see one with water in it let alone wet test. My initial take is the pressure on the premium, adirondack side is super low and possibly defective. On this side, you can isolate a single seat and if I isolate the "deep tissue" seat near the front by turning all power off to the other two seats and put the jets on low power (jet 2 on low, full power on the dial) with say 100% blue, there is almost no flow whatsoever. On the red it's very minimal. When I turn the jets to high, the water moves, but there is barely a slow out of the lower blue jets and its mostly just a very soft feel. On the red it's a tad stronger, but way far from what I'd expect - my neighbors 20 yr old sundance is WAY more powerful.
The difference on water moved between the Jet1 controlled red whitewater and anything on the Jet2 side is massive to the point where I think I must have something set wrong, or wired wrong etc?
Is this normal? I'd heard this tub was considered to have reasonably strong jets (certainly the whitewater is, but the balance barely move water).
Pool is wired 240/50A and info screen seems to show the right data.