What's the Best Hot Tub

Author Topic: Marquis Summit Jet Pressure?  (Read 361 times)

badfish

  • Junior Member
  • *
  • Posts: 7
Marquis Summit Jet Pressure?
« on: June 21, 2022, 01:24:53 pm »
Hi,

Finally took delivery of a Marquis Summit w/ Microsilk.  It was installed by our dealer and has been up and running for 24 hours.

Due to no stock anywhere, we weren't able to see one with water in it let alone wet test.   My initial take is the pressure on the premium, adirondack side is super low and possibly defective.   On this side, you can isolate a single seat and if I isolate the "deep tissue" seat near the front by turning all power off to the other two seats and put the jets on low power (jet 2 on low, full power on the dial) with say 100% blue, there is almost no flow whatsoever.  On the red it's very minimal.  When I turn the jets to high, the water moves, but there is barely a slow out of the lower blue jets and its mostly just a very soft feel.  On the red it's a tad stronger, but way far from what I'd expect - my neighbors 20 yr old sundance is WAY more powerful.

The difference on water moved between the Jet1 controlled red whitewater and anything on the Jet2 side is massive to the point where I think I must have something set wrong, or wired wrong etc?

Is this normal?   I'd heard this tub was considered to have reasonably strong jets (certainly the whitewater is, but the balance barely move water).

Pool is wired 240/50A and info screen seems to show the right data.

 

Hot Tub Forum

Marquis Summit Jet Pressure?
« on: June 21, 2022, 01:24:53 pm »

badfish

  • Junior Member
  • *
  • Posts: 7
Re: Marquis Summit Jet Pressure?
« Reply #1 on: June 21, 2022, 07:52:46 pm »
Off to super start.. first day of its life was super hot and I think the control board fried itself - at least touch screen is non functioning. 

Good times!

Hottubguy

  • Ultimate Member
  • *****
  • Posts: 2136
Re: Marquis Summit Jet Pressure?
« Reply #2 on: June 25, 2022, 08:05:05 pm »
Jet pressure I have definetely found better on Vector series Marquis. Did the touchscreen get real wet?  Sometimes it needs to be reset at breaker

badfish

  • Junior Member
  • *
  • Posts: 7
Re: Marquis Summit Jet Pressure?
« Reply #3 on: July 04, 2022, 04:59:32 pm »
Touch panel just fried - touch pad action stopped working while the rest was fine.  Replaced day-2 on warranty no issues.

I can see where the Vector might be stronger - seems to push less water overall, but more control possible over where it's being pushed. 

A couple weeks in we are very happy - it's a really solid spa and the jets are ok in certain spots.  It'd better if you could divert the water to single seats but it's not the end of the world.

P

Hot Tub Forum

Re: Marquis Summit Jet Pressure?
« Reply #3 on: July 04, 2022, 04:59:32 pm »

 

Home    Buying Guide    Featured Products    Forums    Reviews    About    Contact   
Copyright ©1998-2022, Whats The Best, Inc. All rights reserved. Site by Take 42