Brand Specific Forums > Hot Spring Spas

Leaking and problematic 2015 Hot Spring Envoy NXT

<< < (2/2)

Leaking2015HotSpringEnvoyNXT:
Not a bad idea on the ACE, but we do like the water quality when the water in in the tub (not on the patio)!  I will look at setting up an ozone system as that is what i had prior to ACE.  Also, my Pulse with ACE (older system) was less prone to eating the cell.  Might be a setting in the UI I missed... I am using the same salt and chemicals from the dealer.  I also use Silk Balance, dealer recommended.

I found the hand jet was not tight at all where the leak is.  I pulled the jet face and found small traces of clear silicone.  Is this how the face is set at the factory?  Could this be the leak?  Is there a clear silicone preferred?

My Tahitian was probably a 2011, we moved in 2012 and I recall that year was around the time I bought it..  I am certain it was a foam-filled tub as I recall the mess I made digging out the lighting.  I will certainly yield this to your knowledge. 

Hottubguy:
Do you mean the face in the tub or the jet body on the backside of tub. They are held into place with a clear silicone from inside the tub. Silicone I use is made by Dow Corning. Others work too I’m just use to that brand and I buy it from Watkins. There item number is 71525 I believe

Leaking2015HotSpringEnvoyNXT:
Thank you.  I also read Boss 801 for under the water line.  I am going to see if I can find either of them local...

Navigation

[0] Message Index

[*] Previous page