Original > Hot Tub Forum

FLO error and SCln message gecko - Spa not heating

<< < (2/2)

CanadianSpaTech:
Same issue though

CanadianSpaTech:
He says once the board is removed from the housing to look at the capacitors and you will see that they are bubbled over and slowing the flow of electricity going to the topside controller causing the error. He also suggests doing a full rebuild of the board by replacing all the relays to freshen up the board so you are not doing this again in a year or 2 with a stuck relay. He said a qualified repair service will see the blown caps right away and is an easy repair and under $200 CAN. It is worth a try as I said before finding a new Gecko IN.XE 5 pack might take months if the UK is anything like finding one in Canada.

Navigation

[0] Message Index

[*] Previous page