Brand Specific Forums > Hot Spring Spas

Some piping with no water flowing?

(1/2) > >>

gbbiv:
I recently purchased a used Grandee model from early 2017.  I’m just getting it running and everything seems ok.  One thing I noticed was that there were a few clear tubes inside that didn’t have any water in them when the tub was running.  Is this normal?  This is my first hot tub so almost no experience to draw from.  Two of the tubes like this are wrapped in a loop.  They seem to head off through the right side of the spa.




I've run the spa and can't find any jets that don't seem to be working.

Hottubguy:
Maybe a ozone line with no ozonator?

gbbiv:
Not sure.... ?

I do have an ACE system and I did see this in there...

Spatech_tuo:
If they are hoses without water and look like they never had water then they're undoubtedly just the air intake hoses that feed air that is drawn into the jets.

gbbiv:
Okay, thanks... one did have a little bit of water in it at startup... but there wasn't any in it when I looked a few days later... they both are somewhat crimped where the are "wrapped up", I guess to take up some slack.

Since everything seems to be working okay, I'll go with that, as long as there is some sort of potential answer.  :)

Thanks!

Navigation

[0] Message Index

[#] Next page