Original > Hot Tub Forum

Caldera Error Code

(1/1)

huongtranbong:
2016 caldera vanto

So yesterday, as I am still trying to troubleshoot my GFCI tripping problem, I pulled the board out to inspect it.  Board looked fine so I put it back in, attached all wires, and ensured the setup was correct (software jumpers).  Fired it it, and all worked.

Today I went out to check on it.  Pump 1 low speed works, but when i push pump 1 high speed I get a ===== code with READY and JETS flashing and the pump cuts off.  When i push Jets again, pump 2 comes on just as it should.  Therefore, pump 1 high speed is the only thing not working (not even a year since this).  This happened previously and the pump was replaced under warranty.  The manual says the code means the pressure switch is open.  Why would this happen all of a sudden?  Or is there another meaning to the code

Hot tub is at the correct temperature..


Also - does ANYONE have any service manual information on these tubs.  There is literally nothing on the internet. I cant stand not being able to troubleshoot or know what the jumpers mean, etc.

wmccall:
Welcome to the forum!  I just wanted to say that till one our Caldera experts come along.

Hottubguy:
When the second pump comes on is the first pump coming on too or staying off?

castletonia:
Is the water level high enough and is the filter clean? 

Botswana:
This is word for word  my post from a while ago. This may be a fake/spam account..

Navigation

[0] Message Index