Original > Hot Tub Forum

Hot Spring remote

(1/2) > >>

dishdude:
2014 Envoy. Is it possible to swap this remote out for a conventional control panel? I have no interest in controlling the tub by remote and it's been nothing but trouble from day one. The last time they replaced the dock it was just glued into place with silicone and plugs right into the control panel, so I can easily do the swap myself if it's compatible with the controller.

dishdude:
What a nightmare, the hot tub is now turning the jets on by itself and heating to temps higher than it is set to.

bachman:
I don't know anything about that tub or controller but I'm guessing it has a short in it or something at the 'dock' is getting wet ?
Is the remote like a tablet or something ?

Seems like you could kill power to the remote (take battery out) to see if that isolates the issue. If something is changing the jet configuration and temp settings, that's all I can think of but I'd guess you still need to isolate the problem source. From there, you could consider getting service or parts advice or source it as a DIY.

d00nut:
A 2014 is still under warranty.  I'd have it replaced if it is giving you trouble.  I'm not sure if it is possible, but there is a touch screen that is hardwired on a lot of the new highlifes, that works the same, but isn't a remote.  I'm not positive it can be retrofitted or now. 

There are like 25 different channels that you can set that thing on to make sure you find one with no interference, sometimes it's not the remote at all, but the channel it is on.  Mine works flawlessly on channel 24.  It's not quite enough to just swap out the panel, pairing it correctly is the key.

castletonia:
Also, since it should be warranty, replace the dock and remote at the same time. 

Navigation

[0] Message Index

[#] Next page