Original > Hot Tub Forum

Hot Springs heater bypass

<< < (2/2)

Chas:
Ready light will only come on if the water is within three degrees of the set temperature. That temp setting will only go down as low as 80.

The control panel is pn 73225, no way to rebuild it that I know of.

HTH

 8)

Dougstermd:
Thanks so much for the information. Was going to buy a heater local but to guy said just reuse the sensors . All advice here says put in new sensors with a new heater

Chas:
The new heater usually comes with new o-rings, and I reuse the temp sensors unless they show signs of leaking, or I have other reasons to doubt them.

You can always replace them later if needed.

HTH

 8)

Dougstermd:
I was worried that a bad high temp sensor would allow a runaway heater causing damage to the new heater. The local expert and my online expert suggest otherwise. I think I will take yalls advice. After all that’s what I came here for.

Navigation

[0] Message Index

[*] Previous page