Original > Hot Tub Forum
GFCI Tripping
Hottubguy:
--- Quote from: gmdodt on March 30, 2018, 09:22:13 am ---Tman, or anyone else...the tech that came out somehow got into a service/setup menu on the top controls. Does anyone know how to access that? Also, what happens if I push the "setup" button on the main control board?
--- End quote ---
On the main board there is a black button about 2/3 of the way on the right hand side. Push that in for a couple seconds and it puts the tub into service mode
Tman122:
Tubs should have an on board PC and port for diagnosis. Like a car.
Botswana:
--- Quote from: Tman122 on March 30, 2018, 02:44:44 pm ---Tubs should have an on board PC and port for diagnosis. Like a car.
--- End quote ---
I see a USB port on it but I'm guessing it isn't as easy as connecting a PC to it. I'm assuming there is software needed?
Botswana:
--- Quote from: Hottubguy on March 30, 2018, 09:47:51 am ---
--- Quote from: gmdodt on March 30, 2018, 09:22:13 am ---Tman, or anyone else...the tech that came out somehow got into a service/setup menu on the top controls. Does anyone know how to access that? Also, what happens if I push the "setup" button on the main control board?
--- End quote ---
On the main board there is a black button about 2/3 of the way on the right hand side. Push that in for a couple seconds and it puts the tub into service mode
--- End quote ---
Thanks...anything in there you think will help me? If I end up replacing the board I assume I'll have to use this and set it up for my tub using the configuration settings in the cover panel? A bunch of lines and stuff
Sllick:
Hey there I have an old 2003 spa that I have replaced the heater and the pressure switch the wet end and the main pack board. They spa was working great I'll a couple of days ago when the GFCI 50 amp Breaker tripped and won't stay on....I have only one 2 speed pump...and have checked heater and pressure switch it still trips. I have disconnected power to breaker and the breaker holds does not trip.........So now my question is when I can get breaker to stay on the pump starts purge and gets to end of purge breaker trips....I am wondering if the capacitor on the motor is causing this...or if it is something wrong in the circuit board....this is odd as there is not visible signs of damage to board all wires are snug and filter is out....no ozonatator or blower it is just a simple 2 speed pump
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version