Brand Specific Forums > Marquis Hot Tubs
Marquis E660 "Bubbling" inline dispenser
pRox68:
Hi all, long time lurker, but finally received my new e660 and have some technical questions. First one is, my "inline dispenser fitting" bubbles whenever the pumps are on. I DO NOT have the microsilk feature, so i'm not sure why this fitting has water moving through it or, more puzzling, why it is bubbling (large bubbles, little pressure). This is the fitting in the foot well right under the highest seat and is called out as the inline dispenser in the manual. Not sure if this is normal or if there are some bad connections?
Any ideas / knowledge from the Marquis experts here?
Hottubguy:
Is it your ozonator line? Does your tub have a ozone system?
castletonia:
If you have the inline system, the water that goes into it has to get back to the hot tub somehow. Regardless if you use the system, water moves through it.
As for the bubbles, not sure on that as I never recall seeing that. Very likely there is nothing wrong.
pRox68:
Thanks for the replies..
@Hottubguy: There is an ozonator installed, so my first guess was this was ozonated air bubbling out through the fitting / inline dispensing loop. How would one tell if it was ozone? Smell?
@Castletonia: It doesnt appear to be an issue, I was just wondering what it is. Like, if you do not get the microsilk option, is there still a plumbing circuit there? If so, where is the air coming from? More of a mystery and I dont like mysteries!
meriflower:
I have a Marquis Spirit and it is as Castletonia says. Mine bubbles when jets are on and is normal. The below link provides a diagram of their system showing both the inline and ozone. I believe the ozone comes on during a clean cycle. MicroSilk is only available on the Signature series not on the e series.
http://www.marquisspas.com/hot-tubs/constantclean/
Navigation
[0] Message Index
[#] Next page
Go to full version