Brand Specific Forums > Jacuzzi Hot Tubs

Jacuzzi J-375 control panel blank

(1/3) > >>

Buck Mark:
I have a 2006 Jacuzzi J-375 and the control panel is blank. The backlit display works but I cannot read the letters and numbers on the display. I drained and cleaned the tub today and when I turned the breaker back on, the panel was garbled. There's no error message, just a few lines here and there. Could the panel have gotten wet when I cleaned it? If so, is it fried or is there a way to dry it out. The breaker stays on but the jets and waterfall (etc) do not function. I've tried pressing the buttons on the control panel to no avail. Any help is greatly appreciated!

Hottubguy:
Sounds like the topside controller is done. Are the pumps running?

Buck Mark:
I cannot get the pumps, lights, etc to turn on because I cannot read the display. Even when I turn on the breaker nothing at all happens except the backlit display turns on.

Buck Mark:
Actually, I turned the breaker on again today. Now, the jets turn on (for about 5 seconds) and then turn off. Then, they turn on again (for about 5 seconds) and then turn off. My topside panel is still blank. Any thoughts?

BullFrogSpasMN:

--- Quote from: Buck Mark on December 28, 2015, 04:51:53 pm ---Actually, I turned the breaker on again today. Now, the jets turn on (for about 5 seconds) and then turn off. Then, they turn on again (for about 5 seconds) and then turn off. My topside panel is still blank. Any thoughts?

--- End quote ---

call your local dealer and have the topside replaced, it sounds completely fried

Navigation

[0] Message Index

[#] Next page