Brand Specific Forums > Jacuzzi Hot Tubs
Leaking manifold Jacuzzi J-355
dennisoates:
The leak is at the blue line more towards the center of the pic ,at a coupling. How do I remove this and repair this major leak, it is from ice damage I think. It is packed with foam and I removed quite a bit. Do I have to cut a hole in bottom of the base to access this area,? This is on the manifold and there are 8 lines attached to this and its a tight area. any tips or suggestions would be appreciead.
http://www.flickr.com/x/t/0095009/photos/rainbowtawas/9438083570/
Jacuzzi Jim:
Your tubs only 2 years old why don't you call your dealer, and you seem to be the original owner, not bought from some lady??
TwinCitiesHotSpring:
if it is in fact at the coupling on what appears to be rigid pipe its going to be a severe pain in the you know what...you going to have to dig it back as far as possible and cut it with probably a "wire saw" in order to fit new couplings and a piece of flex pipe in there
dennisoates:
ice damage is not covered by warranty Jim
Jacuzzi Jim:
--- Quote from: dennisoates on August 04, 2013, 03:58:53 pm ---ice damage is not covered by warranty Jim
--- End quote ---
I'm not entirely sure you have freeze damage there. Usually when/if I see freeze damage it's at the pump housing/ pump unions or heater housing. Not buried in foam at a manifold/connection. And freeze damage is most times a big crack, not a drip, from a glue joint.
Navigation
[0] Message Index
[#] Next page
Go to full version