Brand Specific Forums > Jacuzzi Hot Tubs

Jacuzzi Rubber Piece

<< < (3/3)

TdiDave:
Good luck on getting that little o-ring to stay in place when you replace the filter.  Mine is too big for the threads and just falls off as you drums the filter down to thread in.

RunItRagged:
Could be worse...  I have a NEW J-470.  Open Flow Switch error from the get go.  Took out the filters.  Noticed the stupid O ring setting in the bottom.  Ran the pumps and stuck a hose down the hole (2 piece filter side) to clear the error.  Forgot about the damn O ring.  O ring is Gone, baby GONE.  Great suction on the other side.  I'll let you all know how much this will cost me.

RunItRagged:
Talked to the repair dude at the dealership.  He said the "open Flow Switch" error should go away once the filters are cleaned.  (Well water with high mineral content.)  He said to run it without the filters for a day or so and it should clear itself.  It did!
He agreed the O ring was a dumb idea but I  should not worry about it.  He said it will either get chopped up by the impeller or lodge somewhere without any problems.
So far it is running normally and no other problems have surfaced.

Navigation

[0] Message Index

[*] Previous page