Brand Specific Forums > Jacuzzi Hot Tubs

Jacuzzi J355 FL1 and --- error messages

(1/2) > >>

spartacus_33:
Noticed that my hot tub was powerless the other day... turned out to be the 30 amp fuse in the controller box.  I replaced the fuse and am now getting the dreaded "FL1" error that eventually becomes the "---" error.  The red light (heater indicator) is also OFF.

I read the topic post http://www.whatsthebest-hottub.com/forum/index.php/topic,12379.msg155010.html#msg155010 and tried all the things mentioned there.

I removed the filters, turned off the spa for 15 minutes, then turned back on.  The red light came back on.  I placed my hand over the filter inlet to check for suction.  When the spa tried to fire back up... I felt a brief suction against my hand... then nothing and the display went back to FL1.  The red light went OFF.

The spa is under warranty, (except for the service call).  Is it time to call the Warranty Service guy?

Also... any recommendations of a place for buying replacement filters?  These filters at roughly $45/ea.   :o

Thanks,
Steve

spartacus_33:
Turns out it was the little circulation pump.  Of course my tub is 6 months out of warranty.  Cost of this little gem:  $360.00!!!   :'(

Chas:
Installed?

 8)

spartacus_33:
Nope.

Jacuzzi Jim:

--- Quote from: spartacus_33 on June 16, 2013, 10:57:48 pm ---Nope.

--- End quote ---


  Did your dealer put it in or other repair guy?


http://www.spaandpoolsource.com/6500-035sm-909-nhw-1834sundancejacuzzicirculationpumppump230240voltwillshipthe6000-125initsplace.aspx

Navigation

[0] Message Index

[#] Next page