Brand Specific Forums > Jacuzzi Hot Tubs

2004 Jacuzzi J-335 - FL1 Error

(1/3) > >>

fantom:
2004 Jacuzzi J-335 which has a FL1 Error message.  I checked voltage to the flow switch and was not getting any reading. Also, checked the flow through the switch while the circ. pump was on and off and it remained the same so I was told to replace the flow switch which I did. After the replacement, I am still getting the FL1 error so I removed both filters and checked to see if I was getting suction at the bottom of the filter where the mesh grid is located. No suction whatsoever and the temp. remains at 47º. I hear the pump running but I am not sure what to check at this point. Could anyone help me troubleshoot my problem and point me in the right direction?

 :'(

TIA
Phil

Jacuzzi Jim:
 If the circ pump is running you probably have an airlock in your circ pmp.   Take a garden hose with a dish rag wrapped around the end, hold it down on the side with the screen and create a seal to force the air out of the system. Note hose must be turned on  ;)   See what you get! 

fantom:
Thanks for the prompt reply Jim,

OK I held the hose wrapped with the rag on the screen side for about a minute and no suction and still had the FL1 error. I proceeded to change the hose/rag to the open end (other filter side) and did have suction. I held the hose and rag over the opening for as long as I could take it since it was 47º (about a minute) and still get FL1 error. I tried the pump in stage 1 and stage 2. Next?

Jacuzzi Jim:
 Sounds like your circ pump has failed, the flow error has nothing to do with the main pump.  Take your volt meter and check and see if there is power going to the circ pump, if so and it's not running the pump needs to be replaced..   6000-125 is the current Jacuzzi part number.

fantom:
ok Jim,

I am assuming the circ. pump is the pump located just under the flow switch? My pump is labeled 6500-267.

Navigation

[0] Message Index

[#] Next page