Brand Specific Forums > Jacuzzi Hot Tubs

Reprogramming a Jacuzzi for 60 amps

(1/3) > >>

planetary:
In anticipation of my 470's delivery next week, I've done some reading and I infer that the default setting from the factory is for 50 amps service, and it's configurable via the J-1000 control panel (and not dip switches, etc).  Great!  ...But in reading the 2012 Jacuzzi user manuals, I couldn't find instructions on how to actually perform the change.

I have Googled a bit, but come up dry.  So I apologize if this is a FAQ, but does anyone know the procedure?

Cheers!

Jacuzzi Jim:
 I can't remember the sequence and can get it on Monday for you,  but you call always try 1-800 call your dealer  ;)

planetary:
Called the dealer, said it would require a post-delivery service call.

Anyone know the trick?  I'm pretty competent with the computers. :)

TwinCitiesHotSpring:

--- Quote from: planetary on September 17, 2012, 04:35:29 pm ---Called the dealer, said it would require a post-delivery service call.

Anyone know the trick?  I'm pretty competent with the computers. :)

--- End quote ---

can't they tell you how to do it over the phone once your spa is wired and running?

planetary:

--- Quote from: TwinCitiesHotSpring on September 17, 2012, 05:18:11 pm ---can't they tell you how to do it over the phone once your spa is wired and running?

--- End quote ---

Dealer (guy on the phone, not my salesguy) said no, that it required a service call.  That's why it's not in the manual.

Navigation

[0] Message Index

[#] Next page