Brand Specific Forums > Jacuzzi Hot Tubs

Jacuzzi Error "Ono" on pump 2

<< < (2/5) > >>

Jacuzzi Jim:
  So I looked through my old service training book and there is no error like that.   
Here is a list

Sn1
Sn3
ICE1
ICE2
FLO1
FLO2
OH
PnL
---
E###
HOT
COOL
PLUG

Thats it.  I have not done a google search to see what might come op, but typically pump 2 does not cause an error code?

  I am gonna call Jacuzzi next.    Just called them and talked to there service guy.  He had never heard of that one either.  So not sure whats going on?     Does the pump come on or just click?

dfahy:
It comes on both speeds and sounds good then starts to loose pressure. I turn it off and every other time that error code pops up. Figured it was Oh but it really is an Ono or On5. On search so far it doesn't show up. The water level is an inch below the headrest. I could switch the filters and see if they are causing it.
Thanks
Dave

Jacuzzi Jim:
  I just talked to my tech.  He asked if the error flashes off and on or if it stays there.   He also said he has seen it before  but it goes away and the pump works fine and it's nothing to worry about.    So does the spa seem to be working like it should regardless of the error?

dfahy:
Flashes quickly and goes away in about 2 seconds. The code shows up when the pump is having what seems to be a suction issue (best I could come up with). The second it happens I turn the pump off. Just realized I may have mixed up the pump number it is the pump that controls the waterfall and righy corner seat. I plan to take the filter off and add a little more water to see if either of those are the issue. Let me know if you have any other questions or recommendations.
Dave

Jacuzzi Jim:
  Pump 1 draws from a filter and a suction.   Like you mentioned try the filter see if it act the same.  There is not alot that will cause a pump to do that.   Pump 1 filter is the one without the screen where the filter screws into.   

Navigation

[0] Message Index

[#] Next page

[*] Previous page