Brand Specific Forums > Hot Spring Spas

Freshwater III replacement for vanguard

<< < (2/2)

Chas:
Squeeze them - if you look closely you'll see two flat sides - squeeze parallel to those sides. It is not usually hard to get the old one out, but it can be tough to get the new one in because you will have to deform the new cord. Put the thing where you think it needs to be on the cord, and then get it out where you can see it and work on it - and squeeze hard with pliers until you have put a good dent in the cord and it looks like it will go back in.

Or leave the clamp off altogether ... I promise not to tell.

Here is what it looks like open - waiting - hungry for human flesh - the taste of blood - show it no fear.



They make it sound so easy...

buffip:
LMAO
 Thanks!  It woreked just as you said.  New FW III installed, lines + check valves are about 1 year old...now just 2 more issues to work...
1.  Spaudio II recvr is slowly dying...synching is intermittent regardless of channel...need to find a HS modifies audiocast recvr..
2.  Amp wiring to left transducer is bad...need to fix that :-[
The fun never ends
Thanks again

Navigation

[0] Message Index

[*] Previous page