Original > Hot Tub Forum
sundance suntub
burhead:
yes there is a schematic in mine. I will get the pic for you. Sorry I've been working feverisly on this and a couple of other projects so I havent been back here to check this forum.
So I ran the tub on both modes and put an ammeter on each wire. The heater was running on both modes. Then I flipped all the time clock switches to the opposite position and tried both modes again and the heater still runs. Now it is my understanding that in time clock mode, only the pump should be running to just circulate the water. Is that correct? The only thing that could be going on is that since the tub is not up to a high enough temp., the control box is going to call for heat.
I have been fighting the leaks for the last week. Find a leak and fix it, fill tub find a leak and so on. Last night I filled the tub with dye and didn't see any other spots of blue in the foam but one of the joints I fixed continues to leak. I successfully fixed 2 joints by using a wet/dry glue that is supposed to bond to wet surfaces. I used a shop vac to create a vaccuum in the lines and drizzed the glue on and it sucked it into the joint. I did this on the third joint aswell and it looks good but continues to leak. So now I am stuck. The leaking joint is at one of the jets, where the jet assembly meets the flexible pipe. So how do the jets come out of the tub. I guess I am thinking of spicing i a new piece of pipe but wont be able to do so until I can get the jet out of the tub. I ll get some pics tomorrow. Thanks for the help guys.
Dr. Spa™ Ret.:
Just emailed you the manual...would REALLY appreciate the pic of the schematic.
burhead:
here is a pic of the schematic. Sorry they arern't great because the tub is currently up ended and the pump is on the high side. If you need better ones let me know. Thanks again for the manual, it is completely accurate for my year and model.
Here are some pics of my jets and the leaking joint. Looking at it closer today I can't see where the water would be leaking, everything looks sealed up. I was almost wondering if it was leaking elsewhere and following the pipe and running off at the lowest spot of the pipe. The only place it is wet is around the joint and down to the lowest spot of the pipe. So does anyone know how the jet comes out of the tub?
Dr. Spa™ Ret.:
oooooooooo, I think I can make that out
THANKS!
solstars:
I have this exact same tub. Mine is in brand new condition and so is my manual. BTW - press "mode" until the LED turns red. That's continuous mode. Green is the timer mode. Unfortunately, my pump just died last night. Where did you find a replacement?
If anyone needs a clean PDF scan of the manual, let me know.
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version